Kerkau Inspections

Inspection Equipment

Kerkau maintains strict dimensional standards by utilizing state of the art inspection equipment along with strict adherence to the quality manual.  All of Kerkau's finished material is inspected for quality after the first piece of a production run and then every 10th piece that follows, to ensure tolerances are being held throughout the run.  Any deviations from the applicable standards are quarantined and corrected at the time of fault.  This means that you can be assured that from start to finish, your parts will meet and exceed expectation. Kerkau currently has the following equipment in house to dimensionally inspect finished material:
  • Edge Faro Arm
  • Wenzel Smart CMM
  • Magnification
  • Calipers